FastestRaceCar

Competition #1: “Fastest Race Car”
Design – Draw Car to Scale on Draft Paper.
Student Teams will discuss and begin drawing their “Race Car” and then begin the process of drawing it on drafting paper (I will provide it to you). Keep the design and development of this car very simple – the goal is for you to build and begin racing a car as soon as possible. There are a few specifications that all “Race Cars” must adhere to:

Specifications: (Maximum Car Dimensions)

Height: .75 inches (Body of the car, not including w heels.) (5pts.)
Width: .75 inches (Body of the car, not including wheels.) (5pts.)
Length: 2.5 inches. (5pts.)

Drawing: (View Model Drawing below.)
Your drawing must contain:

Front View with Wheels, Axle and measurements. (5pts.)
Rear View with Wheels, Axle and measurements. (5pts.)
Side View with Wheels, Axle holes and measurements. (5pts.)
Axle with measurements (5pts.)
Wheel with measurements (5pts.)

CAD (Computer Aided Design) – Construct the “Fastest Race Car” Using Tinkercad
Students must complete their “Race Car” drawing and show it to the instructor prior to building it in Tinkercad.
The instructor will then export and print the pieces of the student’s “Race Car” on a 3d Printer; the student will assemble the car. Student gets full credit when their “Race Car” prints correctly.
Note: Please review the following issues to insure that your “Race Car” will print successfully:
1. Group the body of the car and the cylinder so that the hole will appear and print.